Quick Delivery CERAMICSPEED Ball Bearing OPD SLT 61802 2RS | 15 x 24 x 5 mm

CERAMICSPEED ball bearing OPD S61801-2RS | 12 x 21 x 5mm

Install and then practically forget about it. The products of the Danish company CeramicSpeed represent the absolute high-end solution for all committed bikers for whom quality and durability are the top priority. The OPD (Optimized Pivot Design) bearings are designed for the rear end of the fully MTB and do their work there permanently and maintenance-free.

In contrast to hubs or the bottom bracket, the ball bearings in the rear triangle or headset do not rotate continuously. As a result, lubricating grease can be pushed aside over time and is no longer in the places where it is needed. The clever minds at Ceramicspeed tackled this problem and developed the SLT (Solid Lubrication Technology) technology.
The main focus here was not on smooth running, but on a permanent oil film. The stainless steel balls are in a solid plastic polymer, which is equipped with countless micropores. The lubricating fluid is located in these. It always distributes the amount required for smooth running and a long service life.
In addition, the “solid” inner workings prevent the seals on both sides from being pressed inwards and water penetrating in the event of mechanical influences from the outside, e.g. when cleaning with a high-pressure jet. Vertical or axial forces can also be better absorbed and distributed, which definitely increases durability and leads to a more direct riding experience, especially at the rear end.
For the corrosion resistance, the choice of material was made of stainless steel. This means that aggressive substances such as salts or chemicals have no chance of damaging the bearings.

The ball bearings are developed and produced in Denmark. This means that Ceramicspeed always has full control over the production process and you can be sure that you only use the best on your bike. In internal tests, they have tried and “failed” to cause their bearings to fail. Therefore, a lifetime guarantee can be given with a clear conscience. Technical specifications:

Material: stainless steel
Bearing type: industrial deep groove ball bearing 61801
Dimensions (inner Ø x outer Ø x height): 12 x 21 x 5 mm
Seal: 2RS – sliding seal on both sides
Design: full complement, SLT (Solid Lubrication Technology)
Colour: silver-red

Weight according to the manufacturer: kA
Weight weighed: 5.8g Scope of delivery: 1x CERAMICSPEED ball bearing OPD S61801-2RS | 12 x 21 x 5mm

EAN:
5711050103355

MPN:
110949